CYCLONE 360 V.3 Tattoo Machine Power Supply Set

Super High Quality Steady Power Weight:500g Measurements: 15.3cm×10.8cm×5.7cm Input AC: 60V-250V 50Hz-60Hz (Worldwide use available) Output DC: 1.5V-22V 2A Capable of running 8-Wrap to 12-Wrap tattoo Machines 1 Foot Switch 1 Clip Cord 1 Power Plug New Cyclone 360 Digital Lcd (4 Display) Tattoo Power Supply Unit Turning Power: Our Multi Turn (10-Turn) Allows you to Fine Tune your Machine to 2 decimal points (0.00) Power: DC 24V (110V-240V Can be used Worldwide) Dimension: 5”(Length) 6”(Width) 2.5”(Height) & Weight: 1 lb Items Included: Power Supply ，Clip Cord, Foot Switch, Power Plug & Instruction Manual SPEED :This part of the display measures the “MACHINE SPEED” in Hertz or cycles per second. A complete cycle would be when the armature bar swings down to hit the Coils. To increase the machines speed you can adjust the contact Screw down giving it a shorter but faster swing. Another way to change speed would be to get a Thicker or Thinner front spring. Having a Thicker Spring will give you a faster speed, while having a thinner will decrease your speed. FOLLOW :This displays the amount of skipping that occurs when your machine is swinging up and down. THROUGH:When the machine is off the contact screw and front spring are touching. Once power is applied to your machine the coils are magnetically charged, Thus forcing the armature bar to swing down. The swing down motion then breaks the connection with the contact screw and front spring. The back spring then forces the armature bar to return back to its original position. If there is any skipping the CYCLONE 360 will display the number of times the skipping occurs. You want to get it as close to ZERO as possible to guarantee a clean follow through. Many factors that may cause this problem would be contact screw angle and gap. Any minor adjustments can alter your follow through. DUTY : This displays the relationship between the contact opening time and contact closing time per swing. CYCLE : The Cyclone 360 can tell you the contact closed time per swing. If the contact point is closed 60% and opened 40% per swing, the LCD will show the closed time of 60%. This helps explain the force of the back spring in relation to the hardness of the front spring. If the back spring is putting a lot of force on the front spring, then you will get a higher Duty per swing. Voltage: The Cyclone 360 will show you voltage up to two decimal places. All machines run at different voltages.The Cyclone 360 can fine tune ALL your machine to the PERFECT voltage. Many factors can change your voltage requirements: Spring Force, Swing Gap, Coil Size, Machine Parts, and more. Different machine require different voltages but ALL machine just require ONE power supply The CYCLONE 360!!!